Wind speed
Cup anemometer with a 0–70 m/s range.
← Agricultural equipment
Wind speed · Wind direction · Separate or combined mounting
RS485 Cup Anemometer & Wind Vane: 0–70 m/s
Build a wind measurement point from a cup anemometer, a wind vane, or both on a combined mounting. Each measurement uses RS485 Modbus RTU. The address and baud rate can be set for the connected logger or controller.
Choose the configuration
Wind direction
Wind vane covering 360°.
Combined mounting
Wind speed and direction on one mounting arrangement. Bare-wire or quick-connector ends; 100 or 150 cm mounting-band lengths are available.
Specifications
| Item | Specification |
|---|---|
| Communication | RS485 Modbus RTU; configurable address and baud rate |
| Power supply | 12–24 VDC |
| Wind-speed range | 0–70 m/s |
| Wind-speed accuracy | ±0.3 m/s or ±0.5% full scale |
| Wind-speed resolution | 0.1 m/s |
| Wind direction | 360°; accuracy ±3°; resolution 1° |
| Power consumption | ≤0.48 W per sensor |
| Material | UV-resistant ABS |
| Operating conditions | -35 to 60 °C; 0–100% RH, non-condensing; IP64 |
| Standard cable | 2.5 m |
| Wind-speed rotation diameter | 180 mm |
| Wind-direction rotation diameter | 295 mm |
- Select wind speed, wind direction or the combined arrangement from the required measurement list.
- Set the wind-direction reference to north during installation.
Where it fits
Farm weather measurements
Add wind speed, direction or both to a facility-agriculture weather point.
Existing RS485 logger
Use the configured device address and baud rate to bring wind readings into the station record.
Outdoor site monitoring
Measure local wind for environmental, weather and wind-power monitoring installations.
Send the details for your equipment list
Include these details with your inquiry so the equipment and options match your site.
- Wind speed, wind direction or both
- Separate or combined mounting
- Bare-wire or quick connector and clamp size
- Point count, logger interface and destination country
Questions about this equipment
Can I order only wind speed or only direction?
Wind-speed, wind-direction and combined arrangements are available. Select the measurements the site needs.
Can the RS485 settings be changed?
The device address and baud rate can be set for the connected Modbus RTU system.
What mounting and cable options are listed?
The standard cable is 2.5 m. Bare-wire and quick-connector ends are available, with no clamp or a mounting band measuring 100 or 150 cm in length.
Connections and related equipment
The equipment list brings together the sensing or control points, supply, wiring, data connection and installation work.