Skip to content
SunGeneAgricultural IoT
← Equipment videos

Tank water level · 40-second overview

Tank Water Level Sensors: Ultrasonic, Radar or Submersible?

Product overview with English on-screen explanations. No audio. Read the chapter summary below.

Start with the tank drawing and the highest water level. An ultrasonic or radar sensor mounts above the water. A submersible probe sits in the tank and measures the pressure of the water above it. The tank layout and water conditions determine which choice is practical.

Compare the equipment and connections

Ultrasonic transmitter

Top-mounted and non-contact. This transmitter has 5, 10, 15, 20 and 30 m configurations.

Choose a range only after checking the clearance at full tank, the connection size and a clear acoustic path.

Radar level sensor

Top-mounted and non-contact. Check the selected model's beam, minimum distance and mounting geometry.

Consider it when the water surface or vessel conditions make an ultrasonic echo unreliable.

Submersible level probe

Measures pressure from inside the tank.

Match the pressure range to the water column, check liquid compatibility and leave access for cleaning and removal.

Logger or controller

Select the input and supply for the ordered 4–20 mA or RS485 configuration.

Check cable routing, sensor power and what the logger should report at high water or on loss of signal.

  • The product photograph shows an ultrasonic transmitter. The other sensing methods are shown in diagrams.
  • When an overflow or pump protection function is required, confirm the local switch, controller and alarm arrangement separately.

Video chapters

  1. 0:00

    Start with the tank

    Mark the sensor opening, the highest and lowest water levels, and any pipes or braces that could obstruct the measurement.

  2. 0:08

    Leave room at the top

    For ultrasonic measurement, leave the required clearance below the sensor at full tank and keep the beam perpendicular to the water surface.

  3. 0:16

    Check the water surface

    Foam, steam or turbulence can weaken the ultrasonic echo. Compare radar and a submersible probe when the surface is difficult to measure.

  4. 0:24

    Match the logger input

    A 4–20 mA transmitter needs a matching analogue input. An RS485 Modbus RTU transmitter needs a compatible serial port and register map.

  5. 0:32

    Send a tank sketch

    Include the liquid, tank height, full and empty levels, mounting opening and distance to the logger.

Specifications and application planning

Send the details for your equipment list

Include a drawing, equipment list or a brief description of the site. These details help us match the instruments and connections.

  • Liquid and tank dimensions
  • Full and empty levels relative to the mounting point
  • Foam, turbulence or obstructions
  • Logger input, power and cable distance