Skip to content
SunGeneAgricultural IoT
← Equipment videos

Soil moisture and irrigation · 40-second overview

Where to Place Soil Moisture Probes for Drip Irrigation

Product overview with English on-screen explanations. No audio. Read the chapter summary below.

A probe reads the soil around its rods. In a drip-irrigated block, the reading depends on where the probe sits in relation to the emitter and the active roots. Plan the locations before ordering probes and cables.

Compare the equipment and connections

Orchard or field

Separate representative soil and irrigation zones when planning probe positions.

Record the emitter offset and depth at every point so the same comparison can be repeated.

Greenhouse bed

Select a repeatable position in the wetted root zone of a representative bed.

Check that the probe rods fit the bed and have good contact with the soil or growing medium.

Three-rod probe

Measures soil moisture, temperature and in-situ EC at one sensing point.

Use field EC for comparisons under similar soil and moisture conditions. Select the range and one output when ordering.

Logger and cables

RS485 Modbus RTU, SDI-12 and 0–2 V are separate output configurations in this probe family.

Check the port, supply, cable length, address where applicable, and the planned recording interval.

  • The depths and distances in the diagrams illustrate placement. Choose the actual positions from the crop, root system, soil and irrigation pattern.

Video chapters

  1. 0:00

    Choose a representative spot

    Mark the emitters, soil changes and irrigation zones. Select a typical position in each zone you want to compare.

  2. 0:08

    Measure at useful depths

    Place the probes at depths that match the crop. Comparing a shallow point with a deeper point helps show how far irrigation water reaches.

  3. 0:16

    Keep the rods in contact

    Insert the rods into undisturbed soil where practical. Avoid gaps around the rods and record the depth and distance from the emitter.

  4. 0:24

    Connect the ordered output

    Match the logger to RS485 Modbus RTU, SDI-12 or the selected analogue output. Plan cable routing and record each probe address.

  5. 0:32

    Read one irrigation cycle

    Compare readings before, during and after watering. Check whether moisture changed at both depths before interpreting the trend.

Specifications and application planning

Send the details for your equipment list

Include a drawing, equipment list or a brief description of the site. These details help us match the instruments and connections.

  • Crop, soil or growing medium
  • Number of irrigation zones and measurement points
  • Proposed depths and cable lengths
  • Logger input, field power and reporting interval