Use this page for factory, plant, warehouse or facility retrofit projects that need equipment state, utility data or environmental alarms delivered to an existing maintenance, BMS, SCADA or IoT workflow.
Remote integration context
Representative site context. Sensors, interfaces, enclosure, power and mounting are confirmed against the actual project before quotation.
What buyers usually need to monitor
Run and fault state
Dry contacts, controller status or documented registers for machine and utility equipment.
Electrical load
Current, power and energy trends used for runtime context, allocation or abnormal-load review.
Environment
Temperature, humidity, leak and cabinet conditions around equipment or critical rooms.
Communication health
Device timeout, gateway heartbeat, network state and buffered records during outages.
Where the hardware sits in the monitoring path
A planning view, not a fixed bundle. Signal type, protocol, power, network and the customer endpoint are confirmed before quotation.
Images show representative product families. The exact model, interface, enclosure and certificates are confirmed against the project before quotation.
List each machine or utility asset and the decisions the data must support.
Separate monitoring from any safety or control function.
Confirm signal types, register maps, sampling rate and retention need.
Check panel power, isolation, enclosure and cable routing.
Define alarm delays, maintenance ownership and escalation.
Confirm whether the customer platform accepts MQTT, Modbus TCP, API or another documented input.
Send this for a useful quote
Asset and point list
Electrical drawings or controller manuals
Signal and sampling requirements
Panel and network conditions
Alarm workflow and platform endpoint
Pilot quantity and rollout plan
Scope boundaries
Monitoring data does not replace machine protection, certified safety circuits or a maintenance engineer’s diagnosis.
Predictive-maintenance claims require a defined sensor, mounting, sampling and analysis method; current or temperature alone is not automatic failure prediction.
Can old machines be monitored without replacing their controllers?
Often yes. Dry contacts, current sensors or supported serial interfaces can provide a monitoring path after the available signals are reviewed.
Does SunGene provide machine control?
The public scope is monitoring hardware and data acquisition. Safety logic and machine control remain with the machine builder or responsible integrator.
Can several machines share one gateway?
Yes when cable distance, addresses, polling load, isolation and gateway capacity are suitable for the planned point list.
